We'll have BOM up on the site very soon. It's essentially the recommended Cavalli BOM, with a few minor changes to accommodate part availability, plus all the additional odds and ends that makeup the complete kit. Luis mentioned some tuning changes. Those aren't part of the stock kit, but will be offered as an upgrade in a bit. It's easy enough to retrofit the stock CTH with this changes later (the case was designed with these upgrades in mind).

Can you please mail me the bom?

That is very reasonable. Please post a pic of an assembled unit when you have one available to be photographed.

What's with the triad transformer? Is taht a desktop transformer or a bare one?

If its the latter, what's the solution for casing it?

Yeah, I remember building my first amp. Bodywork was one of if not the most hardest thing to do. First of all the planning, designing so that it doesn't look too horrifying, then doing a cardboard mockup to check for any errors. And most mistakes at that stage are really costly. I was lucky that I only had one- the pre-amp switch was intersecting with the attenuator ribbon wire. And yeah- it still might look like a rats nest inside:

Is the Joe Audio only offering the full kits now?
I enquired about a couple of PCBs a few days back & they haven't bothered to reply back.